Renovating the bathroom and found these dark patches in the joists and roof lumber surrounding the old vent pipe. The PVC part is new.

Anything bad here? Anything we need to address?

  • OhmsLawn@lemmy.world
    link
    fedilink
    arrow-up
    0
    ·
    11 months ago

    I’m not a contractor.

    I’d poke around for rot and mark the edges to make sure it isn’t spreading. Maybe try to get up there and check after a storm.

    It could absolutely be an old problem that stained the wood. I might make a 1-year calendar reminder if I didn’t see anything after a rain.

  • Hello_there@fedia.io
    link
    fedilink
    arrow-up
    0
    ·
    11 months ago

    Uhh… is it legit to just cut thru beams to put in piping? Over half of those beams are cut thru. I’d ask about that as well. I can’t tell where this is, but if the plumber cut thru load bearing beams to put in plumbing that might be an expensive fix.

    • jubilationtcornpone@sh.itjust.works
      link
      fedilink
      English
      arrow-up
      0
      ·
      11 months ago

      No, it’s not. You can drill holes through the center of a joist or rafter but the permitted diameter of the hole depends on the overall width of the board. Notching the edge (or in this case cutting most of the way through it) dramatically weakens the board since the edges bear most of the tension from the load.

    • davidalso@lemmy.worldOP
      link
      fedilink
      arrow-up
      0
      ·
      11 months ago

      We had the roof replaced two years ago. I believe they redid all the flashing at that point. So there’s a chance this could be old? If the leak is resolved, which I’ll verify, do we have to do anything to the wood or are we good?

      • ricecake@sh.itjust.works
        link
        fedilink
        arrow-up
        0
        ·
        11 months ago

        It looks in the image like there might be some fungus. To me that’s a sign that it’s worthwhile to get someone professional to at least give it a look in person.

      • EccentricaGallumbits@lemmy.world
        link
        fedilink
        English
        arrow-up
        0
        ·
        11 months ago

        I’d call in a separate roofer for an opinion. There are some large gaps in your sheathing where you can see the weather wrap through, and boards that have obvious signs of water damage they left in place. I would want someone else to take a look at this and confirm it’s done right.

      • cabron_offsets@lemmy.world
        link
        fedilink
        arrow-up
        0
        ·
        edit-2
        11 months ago

        They probably fucked up the flashing. Roofers and siders fuck up all the time. If it’s truly an old leak that’s been fixed, you have nothing to worry about. Go up there and observe during the next strong rain. Edit: grab a house key or a screwdriver, stick into the wood. Does it penetrate really easy? Then you’re fucked. Else you’re fine, as long as the leak isn’t active.