Left: I opened a sealed roll of a filament purchased in 2018 and I printed that rose
Right: I dried that filament in the creality dryer overnight and sent the print again
This pic was taken on 10th April. After drying the filament I put it back in storage and I forgot about it until it exploded today
May I ask if you live in an acknowledged high-humidity area?
I live in southern AZ where it is super dry. I never though I needed a filament dryer. I got one anyways and it turns out I did need one. My print are so much better now. Would recommend.
I just recently bought a dryer. When I first got my printer, I was printing pretty constantly and didn’t really have an issue with wet filament. But these days I’ve slowed down my printing frequency a lot, and I’ve definitely noticed that the print quality gets worse the longer I’ve had the roll unsealed.
Just wait until you dial in your smoothing post-proc, etc. methods! Have a blast; your results’re lookin’ great, keep it up! 🤩🖖🏽
It’s crazy easy too. You can get a decent size plasric tote with weatherproof gasket for about $15-20, and a few packs of reusable dessicant packs will.run another $10-15.
For about $30 all in you can keep 6-8 rolls of filament below 10%RH full time with zero hassle.
That’s a good way to keep filament dry, but it takes a very long time to remove moisture from filament that way. It’s a lot faster to use a dryer/dehydrator before putting it in the dry box.
Aren’t silica beads $5 or so a pound? How much do you use?
There are probably cheaper bulk options–but I personally bought some 50g satchets that change color when they start to saturate, for convenience. 3 of those keep a large bin dry for a few months depending on ambient humidity and how often you open it.
Yeah, you can easily order okay to decent quality silica beads for $6-15 a pound(~400g). Same colored stuff that is in the satchets, that you can dry in a dehydrator, the oven or even microwave.
You might be good with what you have, but thought I’d mention it in case you were going to restock or others wanting a bunch to stay safe.
I’m sorry… Why is nobody talking about the explosion?
Yep I have made the same.mistake. The difference is that mine was not.printing at all. Thought the printer was shit or broken, then I dryed the filament. Works perfectly
I live in an area that routinely has 70% humidity. My prints are consistently stringy, and I know it is because of the wet filament. I use an A1 Mini with AMS. Is there a solution, or am I doomed to stringy prints?
Maybe an enclosure with inlet and outlet fans, and either a window AC unit or a dehumidifier dedicated to your printing room? I definitely recommend watching this video before investing in a dehumidifier, a lot of helpful information about how humidity works: https://youtu.be/j_QfX0SYCE8
