Im working with an old reprap cotroled directly with an Laptop with cura. Filament is RS-Pro (2325395) Pla though. Open around 4 weeks ago but i have this problem in some capacity since i have this Filament. Before i had some really old pla which snapped all the time because it wss so brittle. Is this really just shitty Filament? Help/ Insight would be much appreciated.

  • mmddmm@lemm.eeEnglish
    0·
    2 days ago

    I never succeeded in drying filament with the normal cheap ways people post around.

    But I’ve had plenty of luck with a filament drier. Those aren’t too expensive.

    • Stowaway@midwest.socialEnglish
      0·
      2 days ago

      I want a filament dryer, but I’m too cheap, and don’t use my printer enough. :(

      I want to start using it again, but I’ve been struggling to get the motivation to recalibrate and figure out all the optimal settings again.